Размер файла: 193 KB
Количество загрузок: 995
Page 9 G attaching the rear bracket on the back side of the main body. (2) Remove the screw E’ attaching the rear bracket on the back side of the main body. (For KD-G611 model only) (3) Take out the rear bracket. Therefore, pay attention to such burrs in the case of preforming repair of this system. Joint d Joint e (1) Remove the two screws A on the both sides of the main body. Page 28 Signal processing section Compare the L-ch and Is the sound output from No sound from either R-ch to locate the both channels (L, R)? channel. defective point. Normal Is 9V present at IC161 Is 9V present at IC901 Check IC901 and its pin 26? pin 10? peripheral circuits. Page 17 3.2.7 Removing the pickup unit Pickup unit (See Figs.14 to 18) • Prior to performing the following procedure, remove the top cover, connector board and chassis unit. (1) Remove the screw D and pull out the pu. shaft holder from the pu.